SLEEVE AND COTTER JOINT (Assembly)
(i) FRONT VIEW UPPER HALF IN SECTION:
(a) Drawing the upper half of sleeve with clearance and with hatching lines and drawing the lower half of sleeve.
(b) Drawing both the cotters in upper half and in lower half.
(c) Drawing both the rods with clearance and conventional ends with hatching lines.
(ii) SIDE VIEW LOOKING FROM THE LEFT END:
(a) Drawing three circles and conventional hatching at the end of rod.
(b) Drawing cotter.
(c) Drawing cutting plane.
DETAILS :
(a) Printing title.
(b) Scale used.
(c) Projection symbol.
(d) Six important dimensions.
[OR]
FLANGE AND PIPE JOINT (Disassembly)
(i) FLANGE B
(a) FRONT VIEW UPPER HALF IN SECTION:
(i) Drawing the upper half of flange with hole of dia 12mm.
(ii) Drawing the lower half of flange.
(iii) Hatching lines
(b) RIGHT HAND SIDE VIEW :
(i) Drawing four circles and one p.c.d. circle.
(ii) Drawing four circles of dia 12 mm.
(iii) Hatching lines at the conventional end of pipe.
(iv) Cutting plane.
(ii) GASKET
(a) FRONT VIEW:
(i) Rectangle with two horizontal lines of internal dia of 44mm.
(ii) Shaded portion showing rubber material of gasket.
(b) LEFT SIDE VIEW :
(i) Drawing both circles.
(ii) Cutting plane.
DETAILS :
(a) Printing titles.
(b) Scale used.
(c) Projection symbol.
(d) Six important dimensions.
OR